Trims & notes
• #5 moulded zip, 62 cm (centre front)
• 1x1 rib collar x1, hem x1, cuffs x2 (bought as stock-gauge trim)
• 60 GSM taffeta lining (~1.4 m per garment)
• 2 cm stay patches x4 (pocket bar-tacks)
• Woven label (inside back neck) + care label (lining side seam)
• The 8 cm between the chest (58) and the relaxed rib hem (50) is the bomber. Tell the factory it is not a tolerance: a rib cut to the body width gives a straight nylon tube with a stripe at the bottom.
• Catch the zip tape into the collar seam and the hem rib seam. A zip topstitched onto taffeta after the fact ripples along its whole length, and it is the first thing anyone notices on a cheap bomber.
• Use polyester rib, not cotton. The shell is 100% nylon and the two fibres take dye differently; matched at the sample stage they drift apart after a few washes.
• Hang the lining 1 cm longer than the shell and bag it out through the hem. A lining cut to the same length pulls the shell up when the wearer raises an arm, and the hem rib rolls outward.
• Bar-tack the pocket mouths through a stay patch. At 170 GSM the shell is the weakest part of the garment and a bar-tack straight into taffeta tears a hole in it.