Boxy Minimalist · relaxed straight, meant to be worn open

Shawl-Collar Fleece Cardigan

SlabShawl
430 GSM brushed-back loopback, 60 cm chest, 70 cm length, 9 cm shawl collar breaking at 24 cm, five buttons, 5.5 cm rib hem and cuffs, two lower patch pockets
SlabShawl — Shawl-Collar Fleece Cardigan (front) boxy minimalist shawl-collar fleece cardigan flat sketch template front view tech pack vector drawing B chest 60 A length 70 drop 3 E sleeve 62
FRONT
SlabShawl — Shawl-Collar Fleece Cardigan (back) boxy minimalist shawl-collar fleece cardigan flat sketch template back view tech pack vector drawing
BACK

Free vector flat

No account
The drawing above, front and back, as an editable vector — open it in Illustrator, Figma or Affinity and put your own graphics on it. Measurements aren't on the flat; they're in the tech pack.
The vector flat above is free and always will be. The tech pack — graded measurements, tolerances, fabric weights and construction — is the paid part.
Starting spec — make a sample before you order in bulk.
New to tech packs? Read how to make one, step by step →

Fabric

430
GSM · Extra heavyweight · range 390–480
Brushed-back loopback fleece — 80% cotton / 20% polyester. Loopback face, brushed back, enzyme-washed and compacted. Specify compacting: an uncompacted 430 GSM loopback loses 6-8% in length, and on a cardigan that shows up as the collar no longer meeting at the break
Trim: 2x2 rib (hem and cuffs) · 95% cotton / 5% elastane · 340 GSM
What does GSM mean? Read the fabric weight guide →

How it's made

Shoulder
Set-in, dropped shoulder, 3 cm drop — 4-thread overlock + 0.6 cm twin-needle topstitch
Neck
One-piece shawl collar cut on the fold, 9 cm at centre back, tapering into the front edges and breaking at 24 cm from HPS; self-fabric undercollar, no fusing · rib height: 9 cm · topstitch: Single-needle 0.6 cm along the roll line only — the outer edge is left clean
Closure
five-button front · buttons: 5 · button size: 28L corozo, 1.8 cm, 2-hole · spacing: 7.5 cm · note: Buttons start below the break, so the collar rolls over the top button
Placket
Self-fabric front facing 4 cm wide, cut in one with the collar · interlining: Light knit fusible in the buttonhole facing only, 4 cm wide. Fusing the whole facing stiffens the roll and the collar stops rolling
Pockets
Two lower patch pockets, 14 x 15 cm, top corners bar-tacked · position: Lower edge 11 cm above the rib hem seam
Sleeve hem
5.5 cm 2x2 rib cuff
Body hem
5.5 cm 2x2 rib hem. Straight; rib relaxed at 56 cm against a 60 cm chest
Side seams
4-thread overlock, no side panels
Stitch density spi
12 stitches per inch

Size chart

Garment laid flat · M is the sample size
Measure
XS
S
M
L
XL
XXL
A
Body length (HPS to hem) ± 1 cm
66
68
70
72
74
76
B
Chest width (1 cm below armhole) ± 1 cm
54
57
60
63
66
69
C
Hem width (rib, relaxed) ± 1 cm
51
53.5
56
58.5
61
63.5
D
Across shoulder (seam to seam) ± 1 cm
48
50
52
54
56
58
E
Sleeve length (from shoulder seam) ± 1 cm
59
60.5
62
63.5
65
66.5
F
Sleeve opening (rib, relaxed) ± 0.5 cm
10
10.5
11
11.5
12
12.5
G
Armhole (straight) ± 0.5 cm
26
27
28
29
30
31
M
Rib hem height ± 0.3 cm
5.5
5.5
5.5
5.5
5.5
5.5
O
Collar height (centre back, attachment to edge) ± 0.5 cm
8.5
8.5
9
9.5
9.5
10
W
Collar break (HPS to the break point at CF) ± 1 cm
22.5
23
24
25
25.5
26.5
Make a shopper size chart from this template (PNG or Shopify) →Sample back from the factory? Check it against this tech pack →

Colourways

Oatmeal
#D8CFBE
Charcoal
#3A3D3F
Moss
#5A6650

Trims & notes

• Buttons x5 + 1 spare (28L corozo, 1.8 cm)
• Light knit fusible, buttonhole facing (~0.06 m2)
• 1.2 cm twill tape, ~24 cm (back neck, caught under the collar)
• Woven label (inside back neck) + care label (left side seam)
• The break point is a measurement, not a styling note. Put it on the chart (W, 24 cm from HPS) and grade it, or every size will break at the same height on a different chest and the collar will look wrong on half the range.
• Do not fuse the whole front facing. A shawl collar works because the cloth rolls; fuse it and you have a lapel that stands up and gaps at the neck. Fuse the buttonhole ply only, 4 cm wide.
• Buttonholes go in the wearer's left front, below the break. The top button is under the collar roll and the factory will want to move it up where it can be seen — that is the one place it must not go.
• Cut the undercollar in self fabric and cut it slightly smaller than the top collar, so the roll pulls the seam under. Equal pieces make the seam sit on top of the roll where it shows.
• A 430 GSM loopback cardigan hangs from the shoulder, so the shoulder seam has to be stable: tape it or twin-needle it. Untaped, the front edges lengthen unevenly and the two sides stop meeting at the break.